Use a cloth or brush to clean this pr~cisior: Take care of the leveling, use shims under feet of pedestal.ĬLEANING MACHINE. Should floor conditions be such that adjustable foot does nci Socket set screw and raise or lower the foot with a pin wrench so thatĪll four feet rest firmly on the floor. There is an adjustable foot at back right-hand corner of the pedestuiīase to compensate for uneven floor conditions. Leveling should be such as to be reasonable and sithatĬoolant will properly drain back into sump from ends of pan. The three point bearing arrangement makes accurate leveiing With a three point bearing arrangement between bed and pedestalīase. The Hardinge HLV-H Precision Lathe is designed Which w~l ltr ansmit to this machine, a s poor work finish will result. It must, however, be fairly flatĪnd have sufficient strength to support nlachine properly.ĭo not locate machine near other equipment that causes vibration To operate without the need of special foundations. Using the lift truck method than the crane and sling method.Īfter skid has been removed place machine directly on location where Has somewhat more weight at the front and it is more easily tipped
![hardinge hlv-h lathe specs hardinge hlv-h lathe specs](http://permach.com/photos/bg_1206_1.jpg)
To see that the correct balance is obtained. Planks of skid and bottom of pedestal base. When using a lift truck, adjust forks to go in betwsen top The rope or cable must be capable of withstanding a weight of 2000 Lifting with a crane, the rope or cable sling should beĪrranged as shown on this page. The machine may be removed from the skid by either a crane orįork lift truck. Of the pedestal and one at right-hand end. There are two bolts at the extreme left-hand end
![hardinge hlv-h lathe specs hardinge hlv-h lathe specs](https://plumier.org/wp-content/uploads/2020/11/Figure-1Hardinge-1st--768x705.jpg)
Remove the three bolts which hold the nlachine See instructions below for lifting machine from skid. To the location in your plant where it is to be used and then remove Remove crating, but do not remove machine from skid.
#Hardinge hlv h lathe specs manual#
I'll send you the manual if you PM me an email address.